There are several options, that refer to the configuration client and not the service. These can be found under File -> Options
General Options
Choose your language
You can choose from various language packs, devlivered with the client. Please note, that some languages are not fully supported and "English" is the default and suggested language.
Suppress warning when a service is deleted
If this iption is checked, warnings when deleting a service will be suppressed. Such a warning can occur when you try deleting a service and there is no other service using the connected ruleset.
Show autosave warning message
If you make changes in the configuration and switch to another component, a warning will occur if you haven't saved the changes. This warning will also allow you to directly enable auto-saving the configuration.
Always ask to reload application after language change
When you change the language, a popup will ask you to reload the configuration client to properly apply the changes and load with the set language.
Config Access
Load Configuration Registry Path
The Configuration Client can be switched to a different registry path for configuration. The registry path change can be made permanent here. The changed registry path is the saved within the Parameters key of the Service.
Load Configuration from File
Alternatively, you can configure the service to load the configuration from a file. You can set the paths with the two fields below.